Burst-electronics DSR4x1 Manuel d'utilisateur

DSR4x1 DSR8x1 4-Input and 8-Input HD/SD Video Switchers with Analog Reference Video Input Manual Version 1.01 BURST ELECTRONICS INC ALBUQUERQUE

DSR8x1 & DSR4x1 HD/SD SDI Video Switcher 10

DSR8x1 & DSR4x1 HD/SD SDI Video Switcher 11

DSR8x1 & DSR4x1 HD/SD SDI Video Switcher 12

Four/Eight Input HD/SD SDI Switcher Introduction Congratulations on your purchase of the DSR4x1/DSR8x1 HD/SD SDI Video Switcher with Analog Referen

channel. If an analog video input (composite sync or tri-level sync) is present on the Ref Input port, then clean switching between video sources can

change to a dual output you will need only flip the toggle switch, that is recessed in the rear panel, from Ref to Dual. This will negate clean switch

Procomm) is all that is required to communicate with the switcher. The command set for the DSR4x1 consists of a two character command followed by a ca

The DSR switcher will respond with V# (where “#” is the input channel currently selected). RS232 Error Codes Code Descri

will address the unit as #6). After an ID is set the DSR8x1 will flash the embedded LED beneath the input channel number 5 times at power up. To comma

Specifications SDI Input Connectors: DSR8x1 – 8 BNC Input DSR4x1 – 4 BNC Input Supported SD

Front Panel Indicators: LED for standard detection (HD) POWER LED Remote Controls: RS-232 Serial control; 8N1;